16vG60 Edition one project, hopefully !!!

[chunkymunkey003]

mint this is gonna rock!!!

how you get g60 arches? thought theyd gone obsolete?

[EditiononeG60]

think it must be a bit of a rouse to stop people buying them, there are only 10 of each side at the front and a couple of the rear right, left ones are now obsolete

at least all the bad rust is now gone

[EditiononeG60]

now for a little update

Again all parts are genuine vw

new washer bottle with lid and pump grommet



this is a pic of the original PAS pump



and the same pump with all new internals and a lick of paint. powdercoated pulley and fitted with stainless steel allen headed bolts.



This is the ABS pump unit, the whole of the pump and servo unit was in this condition.



after many hours of dis-mantling scrubbing and painting, i reassembled it.





also refitted the front wiper motor assembly, man i dont think i have ever been so bothered about a car as this.

till next time

thanks very much for the support

[chunkymunkey003]

well done mate some serious work going in.....i feel your pain

[Tricky]

This is gonna be the car of the year for me once its finished. The ABS pump unit is a work of art now its finished. Keep up the good work mate

[EditiononeG60]

you guys, i am blushing. This is what happenings when you have too much money and a small brain. should do something sensible like buy a house, thats what the gfd thinks anyway.

got tons done but nothing worth showing, but i did get something special through the post.

These are the 81.5mm 16v pistons for the block.





till the next update people

[j-me]

I love this thread your cars mint and its not even in one piece yet!

when its done it'll be amazing!

[oldskool]

Well done on the build so far. What size pulley you going for and what injectors?what fpr?
Its easier to do the 16v g60 on a proper G60 cos you dont have that silly servo in the way for mounting your alternator next to the bulkhead. I did hear of someone mounting the alernator under the charger but they used off a nissan micra! looks amazing , am sure it wlll be pretty quick once done. Just a side point if i may, you have chosen stainless steel bolts for the abs pump pulley, i would have not done so as they are weaker than hi tensile cap screws. The stainless ones are more expensive but are not as good in tension. My advice is that you get some socket head cap screws that are already hi tensile, theyre cheaper for a start and also will be much stronger.
The scale that they use for the tensile strength is known as ANSI and anything above 8.8 is classeda s Hi tensile, next time you look at the head of a bolt , if theres any numbers on it, this will tell you if its hi tensile, 8.8 is the minimum , you get 12.0 and socket head cap screws are 16.9 which is mega strong. I would swap them for these. Go to any engineering supplies with your existing screws and get a price for swapping them. Other than that well done again. sorry for going on but i would just do it that way if it was me.
Hope this Helps


This post has been edited by oldskool on Nov 28 2009, 12:06 PM